How To Replace A Glass Shower Door Sweep – A glass shower door sweep is a strip of rubber or similar material that is the bottom line of your shower door and prevent leakage when the water is running. If you’ve noticed that the water seems to stem on the floor of your bathroom while you shower, the possibility that whisk you have lost some of its effectiveness. Replacing the belt helps to keep your bathroom dry during a shower Follow these steps to replace the rubber lining for a glass shower door in your home
Before you begin installing a new glass shower door sweep, you must collect all the right materials and tools for the job you’ll need before you begin: New door sweep, Scissor, Screwdriver, Vaseline. Open the shower door and prepare to remove the existing shower sweep. If the sweep is glued to the bottom of the shower, take one of the ends of the sweep and steadily pull away from the door swipe until the whole piece is gradually loosening. If you find it difficult to determine the appropriate size sweeping replacement, removing sweep into a hardware store to match it with a new height.
Use scissors to cut the new glass shower door sweep, so it is the same length as the old At this point, the two sweeps to be exactly the same height and length. Install the new sweep at the base of the shower it should fit, very tightly and creates an airtight seal so that water cannot leak out from the bottom of the shower. Or if it seems a little too hard to fit in the shower, use petroleum jelly to lubricate it. If the sweep is too long you must adjust the new size with scissors.
12 Picture Gallery: How To Replace A Glass Shower Door Sweep
This post topic: Glass Doors