Bay Window Curtain Rod Home

Aug 30th

Installing a window curtain rod is a simple task requiring no special tools or advanced skills. The components of a whole window curtain rod extension bars include three and four mounting brackets. The supports are installed on the sides of the central window receiving both the central rod and the left or right of the curtain. The support is hinged to accommodate windows set at various angles. The installation can be done in less than an hour when even a novice do- Bay Window Curtain Rod Home it yourself.

bay window curtain rod argos
Bay Window Curtain Rod Argos

Pencil bay window curtain rod home Tape measure Drill and drill bit Wall anchors Screwdriver Determine where to place the curtain rod relative to the top of the window. Weakly mark the position of a side stand on the wall with a pencil. Measure the distance from the top of the window frame to the brand and from the side of the window frame to the brand. Transfer measurements to mark the positions of the other mounting brackets so the curtain rod is level and symmetrical. The hardware center rod is mounted on the center window as close as possible to the angle between the windows. Locate and identify the bars left, right and center. Place the components bar the bay window on a flat surface, as will be installed above the window, with appropriate mounting brackets into place. With reference marks, hold a mounting bracket on the wall frame or window. Mark the position of the screw holes hardware pencil-tip passing through each screw hole and make a point on the wall. Remove the bracket. They repeat until positions of the screw holes are marked for four supports.

12 Photos Gallery of: Bay Window Curtain Rod Home

Image of: Bay Window Curtain Rod Argos
Image of: Bay Window Curtain Rod Amazon
Image of: bay window curtain rods australia
Image of: Bay Window Curtain Rods at Walmart
Image of: Bay Window Curtain Rod Walmart
Image of: Bay Window Curtain Rod Target
Image of: bay window curtain rod system
Image of: bay window curtain rod ikea
Image of: Bay Window Curtain Rod Home Depot
Image of: Bay Window Curtain Rod DIY
Image of: Bay Window Curtain Rod Connector
Image of: Bay Window Curtain Rod Bed Bath And Beyond
 

Window Curtain Rod With New Ideas

Drill horizontal pilot holes through bay window curtain rod home each screw whole mark in the window frame or wall. If the hardware is mounted directly to drywall without the backing of wood, drill a hole large enough to accommodate a plastic wall anchor. Insert the anchor into the hole. Repeat to make the screw holes for each of the supports. A central hinge bracket first aligning the mounting bracket holes with the holes in the wall frame or window. Pass a screw through the hole in the bracket into the corresponding hole in the wall frame or window. Tighten the screw with a screwdriver. Repeat to install the second center hinge bracket. Install the outer supports in the same manner. Yet mounting hardware installed, you are ready to hang the curtain.

Leave a Reply